CANNA Additives

We recommend to use PK 13/14 always for one week when you use CANNA nutrients. The CANNA base nutrients already contain sufficient P and K during the rest of the cycle. There is a certain period during the flowering stage though, when we can't increase the feed for the plant any more, so we adjust the PK-ratio by adding PK 13/14 for that one week.

Light breaks down iron chelates! Because of this, it is very important to ensure that no Ultra Violet light reaches the nutrient solution. Light also causes algae to grow in the nutrient solution, which can lead to blockages. Furthermore, algae can take up nutrient elements and cause nutrient deficiencies to occur.

Keep a record of the amounts of nutrients and additives you add to each tank of nutrients you mix. You then have a good starting point for the next time!

Take your time diluting and adjusting your nutrient tank! This is essential for the growth, flowering and development of the plants and will yield the best results.

The products designed to adjust the pH are concentrated products. It is sometimes difficult to adjust the pH correctly in one go. To make life easier for yourself, dilute one part pH adjuster with ten parts water and use this to adjust the pH in your nutrient tank.

Check and adjust the nutrient reservoir as follows: Take a reading of the EC/ppm and pH of the nutrient solution and then determine whether there needs to be adjustments. Use the EC/ppm reading to determine if your concentration needs to be higher or lower, based on the values shown in our grow guide. Use the pH value to determine if an adjustment is needed and if so, try to correct the pH value at the first attempt!